Learning How To Install Pocket Doors
Pocket doors are a great way to create a large passage from room to room without having to give up any space. While a regular door needs room to swing out, a pocket door neatly slides into the wall. You don’t need to make sure you have enough room for the door to swing into a room or hallway, giving you a possible extra ten feet of space. Pocket doors are one answer and a great solution to the tight space issue that you are dealing with. However, these doors are more difficult to install than regular doors. Therefore, if you want to install pocket door then you must learning how to install pocket doors properly. Thankfully, you can find plenty ways about how to install pocket doors in the internet as well as in this article.
Understand About How To Install Pocket Doors
Here are some information about how to install pocket doors. Pocket doors can free up so much space in the room that once you have one you will want to replace all of your doors with them. Framing them in can be difficult because you have to demolish part of your wall to do it. What is behind that wall could be the problem. You may have to reroute electric or cable wire and outlets. Or worse, you could have plumbing or heat/air duct work that has to be moved. If you are not familiar with how these systems work then you should hire a professional to move them for you. If the wall is a bearing wall then beam will have to be installed before you go cutting into any of the studs. You should hire a certified builder or construction engineer to make this kind of a modification. If you weaken a load bearing wall you risk the danger of the wall collapsing.
Installation How To Install Pocket Doors
Once you open up the wall you’re probably going to think you’ve made a mistake because the opening will look too big. The rough opening for a pocket door is twice the size of the door plus one inch and we’re not used to seeing this large of an opening for a door. You will find there are many brands of framing kits for these doors. Investing in a good quality framing kit will save you years of problems with your door. Pocket doors have gotten a bad rep in the past for getting stuck, being noisy and falling off the track. The framing is made much better now and this rarely happens if the framing doesn’t warp and is put in nice and plumb. Use metal wrapped studs so they don’t warp no matter what climate you live in. Look for wheel hardware that has a guarantee that says the wheels will not come out of the track. The header must be level and the rough open has to be perfectly square and plumb. To check for square, place string in each top corner and pull them diagonally to the bottom corners. If the strings just touch than the opening is fine, however if there is a gap more than 1/8 inch you will need to adjust the vertical studs.
How To Install Pocket Doors For Any Room
Learn How To Install Pocket Doors
Ways How To Install Pocket Doors
The door should be painted or stained before the hardware is installed. It will be very hard to do a good job finishing the door once it is installed. Once the hardware is put on the door and the door hung it should be adjusted using the adjusting nuts that are built into the hardware. When the door is hung it’s time to reinstall the drywall. Remember not to use nails in the center part of the drywall or you will scratch your door. Remember this in the future also when hanging pictures or decorations. Once the drywall is back in place the jambs and door casing can be installed and the project will be finished. One tip to note. Install the side jambs first and then the top jamb. Use wood screws instead of nails in case you need to take them out later. These were some information about how to install pocket doors. Hope these will helpful for you. After all, if you are looking for a solution to your limited space than we suggest that you begin looking at the various designs for pocket doors and start to learning how to install properly. They offer a modern, elegant or classic design for the homes.